Genicom 3600 Bedienungsanleitung PDF herunterladen (Seite 106)

3600 Printer Maintenance Manual

5-20

Replacing the TTR Supply Hub and Adjusting Plate

To replace the TTR supply hub, the TTR supply hub adjusting plate, or both

parts, you will need some or all of the following parts and tools:

• TTR supply hub, Intermec Part No. 061562-004

• TTR supply hub adjusting plate, Intermec Part No. 062603-001

• Retaining snap rings, Intermec Part No. 501410

• Ribbon supply hub alignment tool, Intermec Part No. T43149

• ESD grounding strap

• Snap ring pliers

• #1 and #2 Phillips screwdriver

To remove the TTR supply hub and TTR supply hub adjusting plate

1. Switch off the printer power and remove the power cord.

2. Remove the media cover, the electronics cover, and the front bezel cover

(refer to “Replacing the Bezel PCB” earlier in this chapter).

3. Raise the printhead. Remove media and ribbon if loaded.

4. Remove the two retaining snap rings and thin washer from the electronics

side of the TTR supply hub shaft as shown on the next page. Retain the

washer. Discard the old snap rings.

5. Pull the TTR supply hub away from the printer and remove the TTR

supply clutch/encoder assembly. Retain the TTR supply clutch/encoder

assembly (this assembly is not a spare part), the nylon washer, and the

thick steel washer.

6. You can replace the TTR supply hub and TTR supply hub adjusting plate

now.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 173 174

Keine Kommentare

Genicom 3600 Bedienungsanleitung Seite 106