Genicom 3600 Bedienungsanleitung PDF herunterladen (Seite 116)

3600 Printer Maintenance Manual

5-30

Replacing the Stepper Motor

To replace the stepper motor, you will need the following parts and tools:

• Main stepper motor and cable assembly, Intermec Part No. 061551-002

• ESD grounding strap

• #2 Phillips screwdriver

To replace the stepper motor

1. Switch off the printer power and remove the power cord, the media cover,

and the electronics cover.

2. Unplug the motor cable from the main PCB and remove the motor from the

motor plate and motor mount bracket.

3600M.061

Screw

(3 places)

Do not install

a screw in this

mounting hole.

Stepper

motor

Motor

plate

Main PCB

3. Mount the new motor loosely to the motor plate with the cable positioned

at the bottom rear corner. Properly mesh the pinion gear with the platen

drive gear and the liner drive gear before tightening the screws completely.

4. Plug the motor cable into the main PCB. Check that the motor cable-to-

main PCB connection is correctly aligned before applying power to avoid

damaging the main PCB.

5. Install the electronics cover, the media cover, and the power cord, and

check the printer for proper operation.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 173 174

Keine Kommentare

Genicom 3600 Bedienungsanleitung Seite 116